Felisatti DC10,8L2 Manual Del Usaurio página 24

Take care not to short-circuit the terminal of
the battery. The short-circuit of the terminal
may cause a fire or explosion doing a
serious personal injury.
2. Charging process
Use only the specified battery and battery
charger. Otherwise battery and charger can
be damaged by fire, explosion,charging
error or overheat.
Figure 4
1) Charging indication
Green Blinks
Red Lights
Green Lights
Red Blink
Yellow Blinks
Be sure to unplug the charger after finishing
the charging.
2) If charging of the heated battery is attempted
immediately after it has been used or
charged, indicator blinks in red (overheat
standby). After the cooling, indication
changes to red glowing and charging begins.
3) This charger detects charging status of the
batery and always keeps the battery in full
charge state.
3. Installing and removing battery
Figure 5
1) Installing.
Set the rotational direction switch at center
position (locked state).
Insert the charged battery into the slot
below the handle until the battery securely
latched with a click.
2) Removing.
Push the battery button once and take it
out to remove it.
Always set the rotational direction switch at
center position when inserting the battery
or changing, carrying or storing the tool.
4. Charge state of the battery
Figure 6
Pulling the switch trigger will turn on the
battery level indicator for about 2 seconds.
1 = Battery 70 - 100% charged
2 = Battery 30 - 69% charged
3 = Battery less than 30% charged
4 = Battery flat of defective
(Blinking/Turn off)
24
: Before charging
: While charging
: Charging completed
: Overheat standby
(Battery overheated)
: Charging impossible
5. Work light
Figure 7
Pulling the switch trigger will turn on
the LED light
6. Reversing the Rotation Direction
Reversing the rotation direction must be
done only when the tool is switched off.
Reversing the direction during operation
may damage the tool
Figure 8
L (Left rotation) : Counterclockwise direction
(for loosening of screw)
R (right rotation) : Clockwise direction
(for fastening of screw, drilling)
Neutral : Rotation lock (for changing the bit)
7. Adjusting the Speed
Figure 9
1) Press the switch
The power tool switch allows the speed to
be increased steplessly up to maximum.
Figure 10
2) Move the speed selector switch
1: Low speed, high torque
2: High speed, low torque
Do not change direction of rotation until
the power tool is at a stand still.
8. Torque setting
1)Screw work
Selection is feasible from among five setting
anges by force (torgue)
adjustment ring.
low setting range when working with small
screw or at soft working material.
high setting range when working with large
screw or at hard working material.
When the tool is reached at the set torque,
the overload clutch begins to work to keep
the tool in the desired torque. You should
set the desired torque in the practical work.
2) Drilling
Set the torque adjustment ring to the drilling
position.( )
The switch has braking function. When you
release the switch, it brings the motor to a
sudden stop. Also, the surplus rotation will
be stopped.
It is very convenient for fastening screws in
soft materials processed.