Mul-t-lock Code Handle Manual De Instrucciones página 5

Operating Instructions Code Handle
Operation - unlocking/locking
Once the Code Handle has been programmed, the
handle can be operated.
1. To unlock, enter a valid user code.
2. To lock, press the lock button.
The handle must be in the 0°,90° or 180° position in
order to lock or unlock.
5 Enter/change user codes
1 2 3 4
Apart from the administrator code the Code Handle
Window can store 4 additional user codes.
The factory administration code must be
changed before a new user code can be added.
a. Before you start, write down the user code on
page 2 (6 digits).
b. Hold the lock button pressed to enter
programming mode. The LED turns steady green.
c. Enter the administrator code. The LED turns
steady green.
d. Press button 1 to select programming of user
codes. The LED turns steady green.
e. Select one of the 4 memory positions by pressing
the corresponding button, 1-4. The LED turns
steady green.
f. Enter the new user code (6 digits). The LED flashes
green.
g. Test the new code by locking and unlocking.
To store additional codes in the remaining memory
positions, repeat the steps above.
6 Audio signal
The code handle is delivered with the audio signal
enabled. To turn it off/on do the following:
a. Hold the lock button pressed to enter
programming mode. The LED turns steady green.
b. Enter the administrator code. The LED turns
steady green.
c. Press pushbutton 2 to turn the audio signal off/on.
The LED flashes green with a beep (audio signals
on) or without a beep (audio signals off).
7
Erase user codes
a. Hold the lock button pressed to enter
programming mode. The LED turns steady green.
b. Enter the administrator code. The LED turns
steady green.
c. Press button 4 to select programming of user
codes. The LED turns steady green.
d. Select which one of the 4 memory positions to be
erased by pressing the corresponding button, 1-4.
The LED turns steady green.
e. Press the lock button to erase the user code. The
LED flashes green.
Window
®
Reset / change administrator code
If you change the administrator code, the handle will
also be reset (audio signal enabled and additional
user codes erased).
See section "3 Enter/change administrator code"
above for instructions.
Lost codes
A new user code can be entered using the
administrator code, see section "5 Enter/Change user
code" above.
If the administrator code is lost, you will not be
able to re-program the handle!
Security
If an incorrect code is entered five times
consecutively, the code handle will be disabled for
3 minutes and cannot be opened during this time.
The purpose is to prevent unauthorized people from
opening the handle. The LED flashes red and the
handle beeps repeatedly during this time.
Batteries & battery warnings
A battery warning is given when the battery capacity
is reduced to a minimum. The LED flashes red
along with a beep every time a button is pressed,
to indicate the need to replace the batteries.
In addition, after entering a correct code, the
LED flashes red along with a beep five times to
accentuate the need to replace the batteries.
Battery lifetime depends upon several parameters
such as battery quality, frequency of operation
for example. With normal usage the batteries
will last for several years. The product is supplied
with GP branded batteries. It is recommended
to use batteries of a well-known brand for best
performance.
If the battery capacity is below minimum, the handle
will not respond at all.
5