Tabla de contenido
Idiomas disponibles
Idiomas disponibles
-
Replace
the
cover
rotating it towards the
position "CLOSE".
-
Old batteries must be
removed and disposed
off in accordance with
current legislation as
they are harmful to the
environment.
ADDITIONAL SAFETY FEATURES
-
Overheating protection: a safety device switches the
heater off if it accidentally overheats (e.g.: air intake
and outlet grilles obstructed, filter clogged). In this
case remove the plug from the power outlet and leave
it unplugged for a few minutes, eliminate the cause of
overheating, then plug the fan heater back and turn it
on again. If the appliance doesn't work please contact
the De'Longhi Customer Service.
Please note: To avoid overheating the appliance, do
not cover it.
Tip over safety switch: a safety tip-over switch turns
-
the heater off if it tips over or is positioned in an improper
way that could jeopardize safety. The appliance emits a
beep and the display will show a blinking dot. After the
appliance has been restored in the vertical position it
will take just few seconds to start on again.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure) and
troubleshooting section.
MAINTENANCE
-
Before carrying out any maintenance, always remove
the plug from the power outlet.
-
During the season when the appliance is being
used, regularly clean the air intake and outlet
grilles using a vacuum cleaner.
-
Never use abrasive powders or solvents to clean the
appliance.
-
Remove the back grille by pulling it outward (Fig. 1).
-
Remove the dust filter that filters impurities from the air
taken in from the room, blow it lightly, then reposition
it in the appliance.
Any other servicing should be performed by an
battery
cover
battery
Fig. 2
(High temperature), see
authorized service representative.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. lf this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help. Modifications not approved by the party
responsible for compliance could void user's authority to
operate the equipment.
7
Tabla de contenido
