Tabla de contenido
Idiomas disponibles
Idiomas disponibles
sides and rear.
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area and
where it will not be tripped over.
- To prevent a possible fire, do not block air
intakes or exhaust in any manner. Do not use
on soft surfaces,like a bed, where openings
may become blocked.
- A heater has hot or arcing or sparking parts
inside. Do not use it in areas where gaso-
line, paint, or flammable liquids are used or
stored.
- It is normal for the heater's plug and cord
to feel warm to the touch. A plug or cord
which becomes hot tothe touch or becomes
distorted in shape may be a result of a worn
electrical outlet. Worn outlets or receptacles
should be replaced prior to further use of the
heater. Plugging heater into a worn outlet /
receptacle/ may result in overheating of the
power cord or fire.
- If the supply cord is damage, it must be re-
placed by the manufacturer, its service agent
or similarly qualified person in order to avoid
a hazard.
- WARNING: Do not cover the appliance while
it is functioning in order to avoid overheating
which may cause risk of fire.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a poly-
thene tape used as carry handle, remove it
before connecting appliance to the outlet.
- Do not use outdoors.
- To disconnect heater, turn controls to off,
then remove plug from outlet.
- Connect to properly polarized outlets only.
- This heater is not intended for use with an
extension cord or outlet strip. Plug the cord
directly into an appropriate wall receptable.
- Check that neither the appliance nor the
power cable have been damaged in any way
during transportation.
- Do not use the appliance in rooms with a
floor area of less than 43 square feet (4mq).
- Make sure that no pieces of polystyrene or
other packaging material have been left on
the appliance. It may be necessary to pass
over the appliance with a vacuum cleaner.
- When switching on the appliance for the first
time, allow it to run at full power for at least
two hours to get rid of the unpleasant smell.
Make sure that the room in which the appli-
ance is located is well ventilated during this
operation. It is normal for the appliance to
emit small cracking sounds when you turn it
on.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
(see fig. 1)
A
ON/OFF button
B
+/- Adjustment buttons
C
Oscillation button
D
"ECO" function button
E
Timer button
F
MODE button
(for selecting the operating mode)
G
Receiver for remote control
H
Power indicator light
I
Back cover
J
Filter
USE
Installation
The appliance may be used on any rigid horizontal surface. Do
not overload the electrical circuit; avoid using the same outlet
for multiple appliances.
Electrical connection
Before connecting the plug to the power outlet, make sure
that the voltage of your electrical system corresponds to the
5
Tabla de contenido
