Install The Hardware; Prepare The Network Cable - Axis Q1910 Manual Del Usaurio

Page 8

Install the hardware

For outdoor use, please install AXIS Q1910-E/AXIS Q1921-E, or see www.axis.com for more
information on outdoor housing and other accessories
Install AXIS Q1910/AXIS Q1921
The instructions below describe the installation of AXIS Q1910/AXIS Q1921.
1. Attach the metal stand to the camera and make sure that the screws and plugs are appropriate
for the material (e.g. wood, metal, sheet rock, stone).
2. Connect the cables, see
Install AXIS Q1910-E/AXIS Q1921-E
The instructions below describe the installation of AXIS Q1910-E/AXIS Q1921-E.

Prepare the network cable

The provided network cable can be connected in several ways. The first option is to use the cable as
is, with the pre-mounted rubber gasket.
The second option is to use the provided plastic M20 cable gland, which must be used to achieve an
IP66 rating. Using any other cable gland may cause water to seep in and damage the camera.
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
AXIS Q1910/-E/AXIS Q1921/-E Installation Guide
Connect the cables,
.
on page 10.