Programming The Wireless Receiver - Dometic MAGICSAFE RRC 90 Instrucciones De Montaje Y De Uso

RRC90
Pink (P16)
Connect this cable to the earth-controlled cable of the alarm system (e.g. DVS90 alarm system).
The P1 socket is for the antenna and does not have to be connected.
➤ Lay the antenna at an interval of at least 1 cm to metallic parts
8.2
Laying cables
When laying the cables, make sure:
• they are not kinked or twisted
• they do not rub on edges
• they are not laid in sharp-edged ducts without protection.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts of the vehicle
can be damaged by drilling, sawing and filing.
➤ Lay the cable so that they cannot be damaged under any circumstances.
➤ Insulate all unused cable ends.
8.3 Connecting the connection cable to the control unit
➤ Insert the plug of the connection cable into the corresponding connection on the control unit.
✓ When the control unit is connected to the power supply, the red status LED lights up for 20
seconds. Then the LED flashes, which means the device is ready for programming.
9

Programming the wireless receiver

Starting the programming mode
➤ Connect the light blue cable to the earth (terminal 31) to start the programming mode.
✓ The red status LED flashes ten times and then remains lit.
I
NOTE
The red status LED is only needed for the programming procedure and can be
removed at the end.
Programming sensors
➤ Open the door, the stowage compartment lid or the window so that the sensor emits a signal.
✓ The red LED on the sensor lights up briefly.
✓ The red status LED goes out briefly to indicate that the programming was successful.
EN
Programming the wireless receiver
7