Cleaning And Caring For The Wireless Receiver - Dometic MAGICSAFE RRC 90 Instrucciones De Montaje Y De Uso

Cleaning and caring for the wireless receiver

Programming the wireless motion sensor (accessory)
➤ Switch the motion sensor on using the switch.
➤ The red status LED on the motion sensor flashes.
✓ The motion sensor has been programmed.
I
NOTE
You can programme up to 14 sensors (including wireless motion sensor available as an
accessory for the alarm system).
Once the fourteenth sensor has been programmed, the red status LED flashes ten
times.
Ending the programming mode
➤ Disconnect the light blue cable from the earth.
✓ The red status LED lights up for 20 seconds. Then the LED flashes continuously.
➤ Insulate and store the light blue cable.
➤ Remove the red status LED.
10 Cleaning and caring for the wireless receiver
A
NOTICE!
Do not use sharp or hard objects to clean the device as these may damage the
components.
8
RRC90
EN