Install Battery; Remove Battery; Charging Your Battery - Pantech Caper Guia Del Usuario

INSTALL BATTERY

1. Insert your fingernail into the slot(1), then push down on
top of the battery cover and slide it off to remove (2).
2. Slide the battery into the slot (3) by aligning the contacts
and push down (4) until you hear the "click".
Correct
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.
If the battery is not correctly placed in the compartment, the handset will not turn on
and/or the battery may detach during use.
Correct
16
Incorrect
Incorrect

REMOVE BATTERY

1. To remove the battery cover, insert your fingernail into
the slot(1), then push down on top of the battery cover
and slide it off (2).
2. Insert your fingernail into the slot (3) and lift the battery
from the compartment (4).
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.

CHARGING YOUR BATTERY

1. To Charge, connect the wall charger. Make sure you
align the connector as shown in the image.
2. Plug the wall charger into an electrical outlet.
If the battery connector is not properly aligned, damage
could occur to the charging connector and the phone may
not charge.
Correct
Correct
Incorrect
Incorrect
01
02
03
04
05
06
07
17