Installation To Concrete Ceilings - PEERLESS Mounts PRG-UNV Instalación Y Ensamblaje

Installation To Concrete Ceilings

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete
anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all
attached hardware and components.
Place projector mount assembly (A) on ceiling as a template and mark the center of the two
3
mounting holes. Drill two 1/4" (6 mm) dia. holes to a minimum depth of 2.5" (64 mm).
Attach projector mount assembly (A) using two concrete anchors (C), two flat washers (F), and
two #14 x 2.5" wood screws (D) as shown. NOTE: Mounting slots on projector mount assembly
allow for 30° (±15°) of rotation before fully securing wood screw. Tighten wood screws (D) using
3/8" (10 mm) socket wrench, phillips screwdriver or 10 mm open end wrench until projector
mount assembly (A) is firmly attached.
Skip to step 5.
WARNING
CONCRETE CEILING
C
A
F
D
6 of 51
ARROW ON TOP OF
PROjECTOR MOUNT
ASSEMBLy INDICATES
FRONT OF MOUNT
ISSUED: 09-30-09 SHEET #: 056-9024-1