Projector Alignment - PEERLESS Mounts PRG-UNV Instalación Y Ensamblaje

Projector Alignment

To adjust yaw (swivel) for threaded rod mounting applications: Loosen locknuts for
10
threaded rods (refer to step four) until projector mount can be rotated. Rotate mount to desired
position and retighten locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount
assembly (A) indicated below until projector mount can be rotated. Rotate mount to desired
position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below.
Pull knob out and turn by hand for easy adjustment or insert #2 phillips screwdriver in end of
knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
ARROW INDICATES FRONT OF
MOUNT
ACCESS SLOT FOR
OPEN END WRENCH
ALLOWS TIGHTENING
OF LOCkNUTS WITHOUT
REMOVING PROjECTOR
A
SCREW FOR yAW (SWIVEL) STOP
(REFER TO STEP 1, FIG. 1.3)
13 of 51
kNOB FOR PITCH
ADjUSTMENT
kNOB FOR ROLL
ADjUSTMENT
ISSUED: 09-30-09 SHEET #: 056-9024-1