Teka HPL-870 Guía Rápida De Uso página 49

PROBLEM
A flashing symbol E:5
appears on the temperature
display.
I have followed the above
instructions but the door
is still locked and
the oven is cold.
The door cannot open,
symbol is lit up; and
00:00 is shown on the
display.
Turn the control dial to
position Piro. The symbol
"P" will flash on the clock
display and a beep will be
heard every 5 seconds.
IMPORTANT
If the oven door is still locked even though you have followed all these instructions, please
contact the Technical Assistance Service.
CAUSE
The oven clock is set but the
oven door is locked.
No specific cause
During the cancellation
process, you have not
waited for the time to finish
and have opened the door
too early.
The P1, P2 or P3 settings
have not been selected.
SOLUTION
IMPORTANT
If the temperature inside
the oven is very high
(above 250 ºC), you will see
that E4 flashes but the time
does not start to count
down. You should wait
until the oven cools down,
which is when the
countdown will begin.
You will see the time left
before the oven can be used
again on the display. When
the display shows 00:00,
symbol will turn off and
you will be able to open the
oven door and use the oven
as normal.
Touch sensor – until the time
remaining for the door to
unlock appears on the clock
display.
Touch the sensor and
you will see the remaining
time on the display.
Turn the temperature
selector to choose a P1, P2
or P3 setting to start the
pyrolysis cycle.
49