Teka HPL-870 Guía Rápida De Uso página 47

To cancel the pyrolytic cleaning cycle,
remember:
a) Cold oven:
– Switch off the oven by touching sensor
.
– You will see the time remaining until the
door unlocks on the clock display.
– When display shows 00:00 and the
symbol turns off, you will be able to
open the oven door.
Problems when operating the pyrolytic function
PROBLEM
My accessories and shelf
supports are damaged.
The enamel colour has
changed or stains have
appeared.
A flashing symbol indicating
" will appear on the
temperature display and an
alarm will sound.
I have programmed the
pyrolysis function, the oven
is working properly but the
symbol is not lit up.
The pyrolytic programme has
finished but the oven door is
locked.
Cancelling the pyrolytic cleaning cycle
CAUSE
You have not removed the
accessories and supports
during the pyrolytic cleaning
cycle.
The chemical composition
of some foodstuffs may
cause changes in the
enamel.
The oven is programmed
to run a pyrolytic cleaning
cycle but the door is open.
Indicator light
work properly.
The oven has not cooled
down to the safe
temperature.
b) Hot oven:
– Switch off the oven by touching sensor
.
– The time 00:00 will be shown on the
clock display.
– The oven's cooling motor will continue to
operate and the symbol
– When the electronics detect that the
oven is cold, you will see the time
remaining until the door unlocks on the
display.
You must replace them and
remove them in later
cleaning cycles.
This is normal and does not
damage the properties of
the enamel.
Close the door to enable the
function to be run.
does not Call the Technical Assistance
Service.
Wait until the oven cools
down and the symbol
turns off.
will be lit up.
SOLUTION
47