Operating instructions
For use in daylight
Inserting the battery
Please ensure that the lens of your Night-Vision
scope is covered by the lens cap. Remove the
battery compartment lid and insert the battery
(1 x CR 123A). Always observe correct poling.
Fully close the battery compartment again.
Switching on
Attention: To protect the sensitive image
tube against irreparable damage, never
remove the lens cap in daylight.
Actuate the main switch (ON). The green LED
display lights up. When you look through
the eyepiece you will see a bright, green,
fluorescing image.
Switching off
Actuate the main switch (ON). When you look
through the eyepiece you will still see the
green image for a few minutes, before it
disappears. This is normal and not a fault,
because the Night-Vision scope always switch-
es off gradually.
19