Installation - Electrolux ERSB51I5ML Manual De Instrucciones

39 electrolux installation

Installation

Before the use of the refrigerator,
remove all packages, including bottom
cushion and foam pads and rubber
belts in the refrigeratory;
Clear the outside and inside of the
refrigeratory with a piece of warm wet
rag (little detergent can be added into
the warm water. Clear the refrigeratory
with fresh water at last);
Prepare a separate two-pole
grounding receptacle. Do not share a
multi-socket with other electric
appliances.
The ground wire must be well
connected and the grounding pole of
the receptacle should be grounded
reliably.
Open the door, take out the
attachments (the bottom decorative
cover), and three setscrews in the bag
of the Instruction. And install it onto
the bottom beam of the refrigeratory.
For operation method, see the
diagram.
Ice-maker uninstall and install
Uninstall
Lift the ice-maker up in the 1
direction,and pull it out in the direction
2, then take it out.
Install
Install the ice-maker , push it to the
end in the 3 direction.
All manuals and user guides at all-guides.com
Bottom-mounted
decorative cover
Screw
1
2
3
Transport
Do not invert, place horizontally, squeeze or shock the refrigeratory. And the
declination angle of the refrigeratory must be no more than 45° while moving.
When moving, do not force too much on the door or top for fear of
deformation.
Placement
Place the refrigeratory at a well-ventilated place and keep it away from heat
and direct sunshine. Never put it at a damp or watery place, for fear of rusting
or weakening the insulation.
The top clearance outside the refrigeratory must be no less than 30cm, and the
clearance from both sides and back to the walls must be no less than 10cm for
the convenience of opening and heat emission.
Put the refrigeratory on the flat and solid ground. (adjust the adjustable legs to
get balance if unstable).
Standing
Do not switch on the refrigeratory immediately after vertical placement. Only
switch it on after 6 hours' standing to ensure its proper operation.
Attention
To prevent damage to the power cord and any consequent incidents, the power
cord should not be covered by the refrigeratory or other objects.
Before switching on the refrigeratory, please check carefully whether the
voltage
Begin to use
Make sure the refrigeratory is located properly and stably and understand all
safety considerations.
After unsealing the refrigerator,to fix lower cover on the refrigerator (If the door
rugged，Please refer to the adjustment instructions which locate in the lower left
corner of the right panel of Refrigerator to adjust.)
1. Unpacking (if the door height is uneven, adjust it according to the adjustment
instruction at the lower left corner of the refrigeratory's right side plate).
installation electrolux 40