Dispenser I/O; Remote Console - Carl Valentin SPE Instrucciones Abreviadas Y Recomendaciones De Seguridad

Dispenser I/O

Keys: , , ,
Key:
Taste:
Key:
Key:
Key:
Key:
Key:

Remote console

Keys: , , , ,
For more information please contact our sales department.
Operating mode:
Press key to select the operating mode. The following possibilities are available:
I/O static, I/O static continuous, I/O dynamic, I/O dynamic continuous, Photocell and Photocell
continuous.
IN signal level:
Indication of signal at which a print order is started.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
x = not activated signal level
s = status can be affected by interface (in combination with Netstar PLUS)
OUT signal level:
Indication of signal level for output signal.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
s = status can be affected by interface (in combination with Netstar PLUS)
Debounce:
Indication of debounce time of the dispenser input.
Value range: 0 ... 100 ms.
Start signal delay:
Indication in time per second of the delay for the start signal.
Value range: 0.00 ... 9.99.
IO protocol:
Indication of interface at which the modifications of input signals (I/O) were send.
Save signal:
On: The start signal for the next label can already be released during printing the current label.
The signal is registered from the printer. The printer starts printing the next label immediately
after finishing the current one. Therefore time can be saved and performance be increased.
Off: The start signal for the next label can only be released if the current label is printed to the
end and the printer is again in 'waiting' state (output 'ready' set). If the start signal was released
already before, so this is ignored.
English
SPE
97