Fellowes POWERSHRED 450M Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
Continuous operation:
Up to 10-minutes maximum
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
10-minutes will trigger 45-minute cool down period.
ADvANCED PRODUCT FEATURES
SilentShred™ Technology
Shreds without noisy disruptions
PRODUCT MAINTENANCE
OILING SHREDDER
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Apply oil across entry Press and hold forward
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery
time for this shredder.
Remove Paper: When illuminated, press reverse (
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
PAPER CARD OR CD
1 2
Plug in and Feed paper straight into
turn ON (I) paper entry and release
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare
occasions the sensors may become blocked by paper dust causing the motor to run even if there
is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
Turn OFF (O) and
unplug shredder
15
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
or
Hold CD/card at edge,
feed into center of
entry and release
2
Locate Auto-start
infrared sensor
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
3
When finished
shredding set to OFF (O)
.
4
3
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
3