Power Failure; Cycle End Signal; Chlorine Outlet - Pentair Water Blaulain SFE Guía De Usuario

S F E

4.10 Power failure

The following conditions may occur in the event of a power failure:
- The power failure occurs during the standby phase, during a parameter reset phase,
during the statistics analysis phase. In all these cases, the module returns to stand by
and displays the clock with the battery on icon, meaning a power failure. If the power
failure occurs during a parameter reset, the reset is closed without saving any changes
made and at the end of the power failure it will be necessary to go to parameter reset
again and make the changes.
- The power failure occurs during a phase transition or a microswitch search. In this
case, the module still displays the current phase, the battery icon is turned on to indicate
the blackout, the turning bar is blocked to indicate that the motor has stopped. At the
end of the power failure, the motor restarts to complete the movement.
- The power failure occurs during a phase of the regeneration cycle. In this case, the
module still displays the current phase, the battery icon is turned on to indicate the
power failure, the time count down is stopped. At the end of the power failure, the
stoppage time count is restarted and the process goes to the next step.
- The power failure occurs during an alarm. In this case, the module still displays the
alarm and the battery icon is turned on to indicate the power failure. At the end of the
power failure, the module remains in alarm status.

4.11 Cycle end signal

If the FC parameter is set to generate an end of regeneration cycle signal (FC parameter
other than CL), a signal of the programmed time is activated at the end of the
regeneration.

4.12 Chlorine outlet

If the FC parameter is set to CL during phase two of the regeneration cycle, the chlorine
generator is activated (on the specially setup boards 7930-04). The chlorine generator has
two outlets activated alternately for one minute each.
27
E
N
G
L
I
S
H