Installation And Connection - Oase BioMaster 250 Instrucciones De Uso

- EN -

INSTALLATION AND CONNECTION

Order of tasks to be carried out:
1. Fit the unit feet (→ Fitting the unit feed)
2. Prepare the filter media (→ Cleaning/replacing the
filter media)
3. As an option: OASE HeatUp Retrofitting (heater)
(→ Retrofitting the heater)
4. Install the unit.
– Install the unit next to or under the aquarium.
Note the maximum head height. (→ Technical
data)
5. Establish the connections (→ Establishing the con-
nections)
Fitting the unit feed
How to proceed:
5 K
· Twist the rubber feet into the openings of the con-
tainer base.
Retrofitting the heater
BioMaster 250/350/600 can be retrofitted with OASE
HeatUp.
· A holding ring is required for fitting (provided in the
delivery scope).
BioMaster
25
50
75
100
150
200
250
300
¡: Suitable l: Particularly recommended
Prerequisite:
· The pump is switched off. (→ Switching off the unit)
N O T E
When the filter is filled with water, water may spill
when the heater is inserted.
· Take measures to collect any spillage.
22
250 350 600
¡ ¡ ¡
¡ ¡ ¡
¡ ¡ ¡
¡ ¡ ¡
l ¡ ¡
–
l ¡
– –
¡
– –
l
How to proceed:
5 L
1. Unscrew the blind plug counter-clockwise and re-
move.
2. Push the heater into the holding ring as far as it
goes.
– Tip: Moisten the glass bulb with water before in-
serting.
3. Fit the heater. (→ Fitting the heater)
Establishing the connections
Assembling the suction unit
How to proceed:
5 M
· Assemble the suction unit.
· Set the flow rate.
· Use a coin to turn the flow regulator in the hose
adapter to MAX.
Assembling the flow-out unit
How to proceed:
5 N
· Assemble the flow-out unit.
– The water distributor can be used instead of the
flow-out pipe.
· Use a coin to turn the flow regulator in the hose
adapter to MAX.
Connecting the hose
The procedure is identical for the inlet (IN) and outlet
(OUT).
How to proceed:
5 O
· Fasten the suction unit and flow-out unit in the
aquarium using suction cups.
5 P
1. Shorten the hose to the required length.
– Chose the length so that the hose cannot kink in
the intended installation position.
2. Screw the union nut onto the hose connector of the
connection unit.
3. Push the hose onto the hose connector and turn the
union nut counter-clockwise to fix the hose in place.
4. Push the other end of the hose onto the hose con-
nector at the suction unit/flow-out unit and turn the
union nut counter-clockwise to fix the hose in place.
BioMaster 250/350/600, BioMaster Thermo 250/350/600