Viper CEX410 Manual Del Usuario página 14

amount of wear and tear, the operators can
increase the cleaning performance of the
machine by adjusting the height of the
vacuum shoe and rolling brush (refer to F5) .
1) Machine running speed label (0
indicates the machine speed from slow to
fast).
2) Rolling brush pressure label (-
Indicates the pressure on the brush is
increasing)
3) Vacuum shoe adjustment knob.
Holding the vacuum shoe adjustment knob
and rotate it in the same direction, move the
vacuum shoe up or down to the appropriate
position.
Control panel (refer to F6).
1. Power switch
2. Water pump switch
3. Vacuum motor switch
4. Fuse (circuit breaker) for roller brush motor
5. Fuse (circuit breaker) for vacuum motor
Machine operation
Prior to operation
1) Inspect power cable and extension cable for
damage. Replace cable if damage is found.
2) Vacuum the area to be cleaned to remove
most of the solid debris before using the
machine to clean.
Operation
Warning: Do not allow the cord to
come into contact with the rotating brushes.
1) Using a hose or bucket, fill the solution tank
with hot water. (max. 120°F/50°C, capacity 9
Gal./35L).
2) Add distributor recommended detergent.
3) Connect the supplied extension power cord
to the machine. Plug cord into a grounded wall
outlet.
4) Turn on power switch and vacuum / pump
switch.
5) To start cleaning, press the spray mode
switch and begin to pull the machine
backwards. (Note: appliance will only spray
when the pump switch is ON and the spray
mode switch is pressed.)
6) Release spray button at the end of the path
and continue to pull machine back to pick up
MAX excess solution.
7) Tilt machine back onto the transport wheels
and push forward to begin next path.
Cleaning tips :
+
1) Run across the surface to be cleaned in
overlapping paths.
2) Let the detergent solution soak for 5 to 10
minutes on heavily soiled areas and repeat
cleaning several times.
3) Work away from power outlet and power
cable in order to avoid damage to the power
cable.
4) Continually check for foam buildup in
recovery tank. Use a distributor recommended
foam control solution . (Note: Excessive foam
buildup will not activate the float shut-off
and may cause damage to the vacuum
motor.)
5) If the brush stops spinning, there may be an
obstruction in the brush. Unplug the power
cable , check the brush and remove the
obstruction.
6) When recover tank is full, or the solution
tank is empty, you must drain the
recovery tank. (refer to draining reservoir)
Operation with accessory tools
(Only recommended/authorized parts and
accessories should be used).
An optional accessory hand tool can be
attached to clean upholstery and stairs.
Operation with hand tool (refer to F7):
1) Disconnect the normal vacuum hose out of
the dome.
2) Insert the accessory vacuum hose into the
dome instead of the normal vacuum hose.
3) Connect the accessory quick connector to
the quick coupler located on the back of the
machine.
4) Turn on power switch and vacuum motor/
14
ENGLISH