Viper CEX410 Manual Del Usuario página 13

Machine model .....................................
Machine serial number............................
Machine components
1. Spray mode switch
2. Power cable hook
3. Power cord
4. Handle tube (stainless)
5. Solution tank
6. Rear wheel
7. Machine Base
8. "Kickstand" pedal
9. Base height adjusting knob
10. Vacuum shoe knob
11. Vacuum hose input
12. Dome
13. Filling port
14. Viper logo
15. Vacuum shoe
16. Control panel
17. Hand tool (Optional)
18. Hand tool spray nozzle
19. Hand tool quick connector
20. Hand tool valve handle
21. Hand tool vacuum hose
22. Cable clamp
23. Base panel
24. Handle adjusting knob
25. Hose clamp
26. Sight tube coupling
27. Sight tube/drain tube for solution tank
28. Vacuum hose
29. Recovery tank drain hose
30. Accessory quick coupler
31. Solution filter
32. Shaft
33. "Kickstand" machine holder
34. Nozzle base
35. Spray nozzle
36. Wear plate
37. "Kickstand" nut
38. Machine assembly bolt
39. Rolling brush
40. Rolling brush holder
(refer to page 3)
41. Recovery tank dome catch
42. Recovery tank
43. Float filter cover
44. Float cover
45. Foam filter
46. Foam filter holder
47. V-belt cover
Vacuum shoe and rolling brush
installation
Vacuum shoe installation (refer to F2):
1) First, place the machine upright on the
floor.
2) Lift the vacuum shoe knob.
3) Insert the vacuum shoe to suction hose and
mounting base in correct position
4) Release the vacuum shoe knob.
5) Pull back the vacuum shoe, if it doesn't
move, the installation is complete
Rolling brush installation (refer to F3):
1) Place the machine to side position.
2) Install one side of the rolling brush with the
locating slot to bearing mounting rack and
press in the other side to rolling brush holder.
Tip：First , squeeze one side of brush and
ensure the end with a groove has been
installed in place and then install the other
side.
3) If the rolling brush rotates smoothly, the
installation is complete.
Handle direction and Vacuum
shoe/rolling brush height adjustment
Handle direction adjustment (refer to F4)
1) The appliance can adjust the height of the
handle according to user's height or personal
operation habit.
2) Hold the handle adjusting knob and
rotate in the opposite direction to loosen the
handle.
3) Adjust the handle to the appropriate
position and tighten the knob.
Vacuum shoe/rolling brush adjustment
When the machine is working in different piles
of carpet or the rolling brush has a certain
13
ENGLISH