Tabla De Contenido; Unpacking; General; Preset Memory Feature - Emerson RCBT100 Manual De Uso

Section
Safety Instructions . . . . . . . . . . . . . . . . . . . 1
1. Unpacking . . . . . . . . . . . . . . . . . . . . . . . . 2
2. General . . . . . . . . . . . . . . . . . . . . . . . . . . 2
3. Preset Memory Feature . . . . . . . . . . . . . 2
4. Installation of Battery . . . . . . . . . . . . . . . 3
5. Setting Operating Frequency of
Transmitter and Receiver . . . . . . . . . . 3
6. Operation . . . . . . . . . . . . . . . . . . . . . . . . 3
7. Installation of Storage Bracket . . . . . . . . 4
8. Installation of Receiver . . . . . . . . . . . . . . 4
9. Troubleshooting . . . . . . . . . . . . . . . . . . . 5

1. Unpacking

WARNING
!
Do not install or use fan if any part is
damaged or missing. Call Toll-Free:
1-800-654-3545
Open the carton containing the Bluetooth
Ceiling Fan Control. Remove contents and
check to see that you have received the
following parts:
1. Transmitter (1)
2. Storage Bracket and Hardware (1 set)
3. A23/MN21 12V Alkaline Battery (1)
TRANSMITTER
4. Receiver (1)
3
2
1
0
STORAGE BRACKET
A23/MN21 12 V BATTERY
Table of Contents
Page
RECEIVER
Section
10. Downloading the Emerson Bluetooth
Ceiling Fan Control App . . . . . . . . . . 5
11. Connecting to Your Fan . . . . . . . . . . . . 5
12. Configuring Your Fan . . . . . . . . . . . . . . 6
13. Renaming Your Fan . . . . . . . . . . . . . . . 6
14. Reconfiguring Your Fan . . . . . . . . . . . . 6
15. Operating Your Fan . . . . . . . . . . . . . . . . 7
16. Adding Additional Fans . . . . . . . . . . . . . 7
Emerson Air Comfort Limited Warranty . . . 8
Spanish . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
French . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Your Emerson Bluetooth
consists of a hand-held transmitter and a
receiver. The transmitter is designed to
separately control your ceiling fan speed and
light intensity. There are four push buttons
(0, 1, 2, 3) to set the fan speed and turn the
fan OFF. The light (
the light ON and OFF and controls the light
intensity. The blue indicator light will illuminate
®
while any button is pressed, indicating that the
battery is good.
The transmitter is powered by one A23/MN21
12V alkaline battery (supplied). To prevent
possible damage if the battery should leak, be
sure to remove the battery when the control is
not to be used for an extended period of time.
Code switches in the transmitter and receiver
may be set in 16 different positions. If your fan
and light go ON and OFF without using your
control, you may be getting interference from
other remote units such as garage door
openers, car alarms or security systems.
To remedy this situation, change the
combination code in your transmitter and
receiver.

3. Preset Memory Feature

Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to the
receiver is powered through a wall switch,
when the switch is turned OFF, the control will
remember the light intensity and fan speed.
When the switch is turned back ON the light
and fan will resume operation as they were
prior to the switch being turned OFF.
2

2. General

Ceiling Fan Control
®
) push button turns
U.L. Model No: MR101F
Page
®