Installation Of Battery; Setting Operating Frequency Of Transmitter And Receiver; Operation; Important - Emerson RCBT100 Manual De Uso

1. Remove the battery compartment cover by
pressing firmly below the arrow and sliding
the cover off the transmitter (retain for
future use).
2. Install one A23/MN21 12V alkaline battery
(supplied).

5. Setting Operating Frequency of Transmitter and Receiver

Your transmitter and receiver have code
switches which must be set in one of 16
possible code combinations. The four levers
(numbered 1, 2, 3, and 4) on the switches are
factory-set in the ON (up) position. Do NOT
use this setting. Change the switch settings as
follows:
1. Slide the four switch levers in the
transmitter to your choice of ON (up) or
OFF (down) positions. Use a ball-point pen
or small screwdriver and slide the levers
firmly up or down.
2. On the receiver, slide the four switch levers
to the same positions as set on the
transmitter. Make sure the levers on both
the transmitter and receiver are in the same
positions, otherwise the fan will not
operate.

IMPORTANT

Fan installation must be completed,
including the installation of the fan
blades, before testing the transmitter.
Your transmitter has full control of your fan
and light.
NOTE: If your fan has pull chains, prior to
operation of the fan and light from the
transmitter, set the fan speed to HIGH and
turn the light ON.
1. To set the desired fan speed, press one of
the four buttons (0, 1, 2, 3) to operate your
fan from OFF to HIGH speeds.
2. To turn the light ON, press and release the
( ) button.

4. Installation of Battery

(Figure 2)

6. Operation

(Figure 1)
ON DIP
1 2 3 4
ON DIM
Figure 1
3. The additional switch on the transmitter
marked ON and DIM is for dimming control
of lights: Set switch to DIM to allow for
dimming of the lights. Set switch to ON for
full brightness of the lights such as for
fluorescent bulbs.
4. Reinstall the battery compartment cover
onto the transmitter.
DIM SWITCH
ON
ON DIP
1 2 3 4
ON DIM
Figure 2
(Figure 3)
3. To vary the intensity of the light, hold the
( ) button down until the desired light
intensity is reached, then release the
button.
Note: When turning the light on, light will turn
on at the light intensity previously selected.
3
2
1
0
Figure 3
Please contact 1-800-654-3545 for further assistance
3
TRANSMITTER
A23/MN21 12 V
BATTERY
BATTERY COMPARTMENT
COVER
TRANSMITTER
RECEIVER
CODE SWITCHES
DIP
1 2 3 4
POWER INDICATOR LIGHT
HIGH TO LOW
BUTTONS
FAN OFF BUTTON
LIGHT BUTTON
emersonfans.com
U.L. Model No.: MR101F