Purpose Of Use; Machine Assembly; Handle Assembly - Fieldmann FZV 4001-E Manual De Uso

5. PURPOSE OF USE

Intended Use
The electric verticutter LS-S3201 is intended for aeration of lawns and grass areas in private
home gardens and garden plots. It is not intended for use in public facilities, parks, sports
grounds, roads, in farm sector and in forestry.
Note
Attention! In order to prevent injury, the electric verticutter may not be used for shrubs,
green fence and bushes trimming. The electric verticutter may also be not used for soil
levelling.

6. MACHINE ASSEMBLY

Handle Assembly

Insert both bottom parts of the handle 5 (ends with round hole) into the holders in the engine
cover 6 and secure them with Phillips head screws 9.
Insert two locking bolts 1 from outside through the holes in two middle parts of the handle 2
and secure the bottom parts of the handle 5 with two wing nuts 4.
Screw the upper part of the handle with the switch lever 3 to the middle parts of the handle 2
with additional two locking bolts 1 and wing nuts 4.
Attention! Warning - Fix the upper part of the handle 3 to make sure that the socket plug 7
with the power supply cable 8 is on the right-hand side ( horní část držadla se startovací
rukojetí 3 tak, aby zástrčka 7 s napájecím kabelem 8 byla na pravé straně (in the direction of
movement) (see Fig.)
Power Supply Cable Attachment
Attach the power supply cable 8 to the handle using two cable clips 10.
Attachment of Fully-Assembled Grassbox to the Lawnmower
Lift the protective guard
Make sure the discharge chute is clean and free of any debris
Locate the fully-assembled grassbox 12, 13 into the locating points in the rear part of the
guard as shown
Attach the safety flap upon the upper part of the grassbox. Make sure the grassbox is easily
attachable.
VERTICUTTER
Purpose of use | Machine assembly
(Fig. 2)
15 EN
USER'S MANUAL