Avaya 10U100 Manual De Uso página 9

60653-01 10U100 UserGuide_r2
general
5/11/01 12:12 AM
s e t u p
Note: On all 6200 sets and some PARTNER telephone
sets (MSL-18D sets), the bridging adapter may not
be required. Simply plug the other end of the long
telephone line cord into the built-in AUX jack on the
bottom of the set.
• At the wall jack, disconnect the existing telephone line
cord for your telephone. Connect the plug you just
removed into the lower jack of the bridging adapter.
• Connect the plug on the bridging adapter into the
wall jack.
Connect the Line Cord
3. Plug the AC power adapter into an electrical outlet
and the DC connector to the back of the base unit.
Make sure that the electrical outlet is not controlled
by a wall switch.
Caution: Use only the AC power adapter supplied with
this telephone.
Set the Dial Mode Switch
4. If you have touch tone service on your line, set the
switch located on the back of the base to TONE. If you
have rotary service, set the switch to PULSE.
Charge the Handset Batteries Before Use
5. The batteries recharge automatically whenever the
handset is in the powered base unit cradle. The batteries
must be charged for 8 hours before using your phone
for the first time.
Check for Dial Tone
6. After the batteries are charged, pick up the handset
and press
talk
and you should hear a dial tone in the headset. If not,
see "Trouble Shooting".
.
8
Page 8
E N G L I S H
. The TALK indicator should light up,