Soundcast VG3 Guia De Inicio Rapido página 6

Bluetooth pairing with NFC
1. Enable Bluetooth and NFC functions on
your mobile device
2. Hold phone near the NFC logo (logo) on VG3 unit
until mobile device connects and Bluetooth
LED blinks slowly
3. Press OK/Connect on your mobile device
to complete pairing
4. Play audio
Standard Bluetooth Pairing
1. Enable Bluetooth on your mobile device
2. Pair a new device: press the VG3 Bluetooth button
(Bluetooth LED will blink slowly)
3. From Bluetooth menu on mobile device settings,
select "VG3 by Soundcast_xxxxxx"
4. Once paired, the Bluetooth LED becomes solid blue
➤ Press & Hold Bluetooth button for (2) seconds and
beep is heard to re-enter pairing mode to pair a new or
additional device.
➤ To clear all devices from memory, press and hold the
Bluetooth button for (10) seconds until the Bluetooth LED
double blinks and third confirmation beep is heard.
Aux Input Mode
Plug external audio source into 3.5mm jack to
automatically switch to Aux Input mode as indicated by
Aux LED turns yellow. Remove 3.5mm plug to switch
back to Bluetooth operation.
Qualcomm TrueWireless™ Stereo (TWS) Pairing
With TWS, two VG3 units may be paired for synchronous
Bluetooth playback. Power off, volume and TWS mode
will by synchronized and may be controlled from
either unit.
1. Both speakers must be powered on in Bluetooth
mode (no Aux input connected)
2. At least one of the speakers must be paired to audio
source (as described above) Press and hold the
TWS for (2) seconds until a confirmation beep is
heard. The TWS LED will start to blink slowly. Repeat with
the second VG3 unit
6
3. When paired, the TWS LED on both units will show
both blue and orange (purple)
➤ When in TWS mode and you turn off one unit, the other
unit will turn off automatically
4. Reconnecting: The TWS-paired units will re-connect
to each other automatically after turning both units on.
A short press of the TWS button on either unit allows
cycling through the TWS modes (stereo, left/right, off)
as indicated below;
• LED blue and orange: left/right
from each speaker
• LED orange only: left from primary
speaker,right from secondary speaker
• LED off: TWS off
➤ To clear all devices from TWS memory and return to
single device operation, press and hold the TWS button
for (10) seconds until third beep is heard and the TWS
LED double blinks, then turn the unit off. When unit is
turned on again, the TWS LED will not be on, indicating
that TWS is disabled.
➤ If you experience any difficulty with either standard
Bluetooth pairing or TWS operation, the VG3 Bluetooth
system can be reset by clearing pairing memory of both
Bluetooth and TWS by using the (10) second press and
hold function (third beep) of each button and then power
cycling the unit.
➤ No music or intermittent dropouts? VG3 primary and
secondary units may be too far away
from each other.
Handsfree Speakerphone Operation
1. If your phone receives a call while paired with the VG3
press the play/pause button to answer the call. VG3 will
become a hands-free speaker phone
2. When call is complete, press the Play/Pause button to
end the call. VG3 will automatically return to your previous
music source
➤ If Keypad Auto-Lock or Child Lock is active when call is
received, the keypad will automatically unlock for duration
of call and re-engage after call completes.
Qualcomm TrueWireless™ is a product of Qualcomm Technologies
International, Ltd.