Gree GCF220BKNA Manual Del Usuario página 13

Display of Dust Degree and Odor Degree
The sensor built-in can sense quality of air and change of odor. Through qty of LED lamps, air
quality and odor content can be known.
Dust
Few
Much
<LED lamp for Dust Sensor >
In below conditions, the LED lamps will be
■
on for the fi rst second which are irrelevant to
air quality.
① Operation after installing front panel
② Operation after plugging attaching plug
When dust sensor lags in response, please
■
revise setting of sensitivity degree of sensor.
※ Setting for Sensitivity Degree of Dust Sensor
① In standby mode;
② Press SLEEP+ AUTO buttons simultaneously for over 1 seconds and then release them;
③ The unit enters adjustment mode for sensitivity degree of dust sensor. In that case, d1, d2
or d3 will be displayed. In initial setting, d1 will be displayed. Number 1, 2,3 means sensitivity
degree. Number 1 means lowest sensitivity degree, number 2 means medium sensitivity
degree and number 3 means highest sensitivity degree.
④ Press +/- button to adjust sensitivity degree.
⑤ Quit: if there is no operation for 3 seconds, the system will keep the current setting of
sensitivity degree and quit the setting mode.
※ Setting for Sensitivity Degree of Odor Sensor
① In standby mode;
② Press FAN + HUMIDIFY buttons simultaneously for over 1 seconds and then
release them;
③ The unit enters adjustment mode for sensitivity degree of odor sensor. In that case, o1, o2
or o3 will be displayed. In initial setting, o1 will be displayed. Number 1, 2,3 means sensitivity
degree. Number 1 means lowest sensitivity degree, number 2 means medium sensitivity
degree and number 3 means highest sensitivity degree.
④ Press +/- button to adjust sensitivity degree.
⑤ Quit: if there is no operation for 3 seconds, the system will keep the current setting of
sensitivity degree and quit the setting mode.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
LED lamp is on
Odor
Few
Much
<LED lamp for Odor Sensor >
In below conditions, the LED lamps will be
■
on for the fi rst second which are irrelevant
to air quality.
① Operation after installing front panel
② Operation after plugging attaching plug.
In fi rst 2 minutes after turning on the unit,
■
the odor sensor is pre-heating. In that
case, odor sensor may not respond.
Except alkaline air, the sensor may not
■
respond to some odor, like odor of pet or
garlic.
Because people have different feelings
■
about odor, someone may still feel there
is odor when Green LED lamp is on. In
that case, please manually switch fan
speed to high speed.
11