Cleaning The Tank; Cleaning The Grill And Drip Tray - Espressione Moka aroma 1337 Manual Del Usuario

an alternative, you can use a simple dishwasher detergent tab (without added rinse aid or other chemical
additives) as follows:
• Put a dishwasher detergent tab into the filter (without coffee) when the machine is hot (after heating for at
least five minutes).
• Couple the filter holder to the machine and put a container underneath the filter holder.
• Press the coffee button to start dispensing water, and dispense the water for 15-20 seconds.
• Stop the water supply and let the tab act for at least 15 minutes while keeping the filter holder coupled on the
machine.
• Repeat the water dispensing operation by operating the pump for about 15-20 seconds, and then letting it
rest for another 15-20 seconds, until two tanks of water are used up.
• Remove the filter holder from the machine, remove the filter and rinse it well under running tap water.
• Turn off the machine, disconnect the power cable from the socket-outlet and clean the coupling seat of the
filter holder with a sponge in order to remove any detergent residue from the shower disc.
• Turn the machine back on, couple the filter holder once again and dispense at least 2 cups of water again to
complete the rinsing.
If the coffee machine is used daily, it is advisable to carry out the cleaning operation at least every three
months.
cleaning the pod filter holder
Start dispensing with the filter holder connected and without the pod inside by pressing the button (S) after
having placed a glass underneath the filter holder. In this way any coffee residue or impurities present in the
filter holder will dissolve and be removed.
cleaning the silicone disc
Wash the silicone disc (E) under running water, bending it slightly on the sides in order to free the centre hole
of any residue of coffee grounds that could clog it (Fig. 12).
cleaning the filter holder seat
Warning!
Each intervention must be carried out with machine off. All elements must be at ambient temperature
in order to prevent residual pressure inside the boiler.
With time, coffee residue may accumulate on the filter holder seat. It can be removed with a toothpick, a
sponge (Fig. 13), or by letting water run through without fitting the filter holder (Fig. 4).
Loosen the screw in the centre of the filter holder coupling seat (Fig. 14) with a 5 mm hex wrench if the machine
no longer supplies water or coffee from the filter holder seat. Remove the spring. Put the spring to soak in a
descaling solution in order to eliminate the residue of lime that prevents its proper operation.
cleaning the maxi cappuccino device
Warning!
Perform this operation when the chrome-plated pipe is cold so as to prevent burns.
Unscrew the device (H) from the small pipe and wash it with running water. The small pipe can be cleaned with
a non-abrasive cloth. Screw the cappuccino maker back on as far as it will go. If necessary, clean the small
steam outlet hole again with a pin. After use, always let the steam nozzle run for a few seconds so to free the
outlet from any possible residue.

cleaning the tank

Periodically clean the inside of the tank with a sponge or damp cloth.

cleaning the grill and drip tray

Remember to empty the drip tray from time to time (a).
Remove the grill (B) and wash it under running water; remove the drip tray (A) from the machine, empty it and
wash it under running water.
9