Background Lighting - DAY Useful Everyday 73365 Manual De Instrucciones

Setting the daily alarm
When the time is displayed, press the ALARM
button once. The display shows the icon for
the alarm and the alarm time.
Press and hold the ALARM button for 2
seconds until the alarm time fl ashes. Use the
UP and DOWN buttons to set the hour.
Press the ALARM button to confi rm the
setting.
The minute number of the alarm will fl ash.
Use the UP and DOWN buttons to set the
minute.
Press the ALARM button to confi rm and
conclude the setting.
Briefl y press the ALARM button to switch the
daily alarm on and off .
NB!
After 20 seconds without any button being
pressed, the appliance switches from setting
mode to displaying the time.
The alarm sounds for 2 minutes unless you
press any button (except the SNOOZE/LIGHT
button) to stop the alarm. In that case the
alarm will repeat automatically after 24
hours.
The volume of the alarm increases in 4 steps
during the 2 minutes the alarm sounds.
Automatic snooze function
Press the SNOOZE/LIGHT button while
the alarm sounds to activate the snooze
function. The alarm stops and resumes again
after 5 minutes.
38

Background lighting

Briefl y press the SNOOZE/LIGHT button to
turn on the backlight for about 8 seconds.
If the weather station is connected to the
adapter, the backlight is lit constantly. You
can adjust the brightness in 4 steps or turn it
off by pressing the HPA/INHG button one or
more times.
Displays
Temperature and humidity
The weather station displays the temperature
and relative humidity indoors and outdoors
on the display.
The temperature can be displayed in °C or
°F. Briefl y pressing the UP button changes
between the two measurement units.
If you press the MEMORY button once, the
highest values registered since the last reset
will be displayed.
If you press the MEMORY button twice, the
lowest values registered since the last reset
will be displayed.
If you press the MEMORY button 3 times, the
current values will be displayed.
If you press and hold the MEMORY button for
around 3 seconds, the stored values will be
deleted.
If the values are lower or higher than the
weather station's measurement range, LL.L or
HH.H respectively will be displayed.
The "TREND" arrows indicate if the
temperature and relative humidity are rising,
stable or falling.