afriso PrimoSol 130-1 Manual De Instrucciones página 45

DAMAGE TO THE PUMP ELECTRONICS
• Verify that the pump is not controlled via an external speed controller which
changes the supply voltage.
• Verify that the pump is controlled with 230 V without phase angle control.
• Switch the pump on and off via the controller.
Failure to follow these instructions can result in equipment damage.
1. Connect the circulation pump in accordance with the enclosed instruc-
tions.
2. Route the connection cable of the circulation pump through the cable duct
to the bottom and connect it to the solar controller. Observe the operating
instructions of the solar controller.
Shielded cable 3 x 1.5 mm² and up to Ø 10 mm can be used to extend the
connection cable.
Mounting
NOTICE
PrimoSol® 130
EN
17