Anti-Tip Bracket - Sub-Zero PRO Serie Guía De Instalación Y Especificaciones

IN S TA L L AT I O N

Anti-Tip Bracket

WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
Use the centerline locating holes to position the anti-tip
bracket in the center of the opening. The bracket must be
positioned 24" from the front of the opening to the
(610)
back of the bracket. This depth will increase to 26"
a flush installation. Failure to properly position the anti-tip
bracket will prevent proper engagement.
Use all anti-tip bracket hardware as instructed for wood or
concrete floors.
IMPORTANT NOTE: For wood or concrete floor applications,
if the #12 screws do not hit a wall stud or wall plate, use the
#8 screws and #12 washers with the wall anchors.
In some installations the subflooring or
IMPORTANT NOTE:
finished floor may necessitate angling the screws used to
fasten the anti-tip bracket to the back wall.
AN T I-T IP H AR D WA RE
1 Anti-tip bracket
1
12 #12 x 2 / " pan head screws
2
3 3 / "–16 x 3 3 / " wedge anchors
8 4
12 #12 flat washers
3 #8–18 x 1 1 / " truss head screws
4
3 Nylon Zip-it ® wall anchors
CENTERLINE
LOCATING HOLES
Anti-tip bracket
8 | Sub-Zero Customer Care 800.222.7820
WO O D FL OO R APPL IC ATI ON
After properly locating the anti-tip bracket in the opening,
drill pilot holes
or wall plate. Use the #12 screws and washers to secure
the bracket. Verify the screws penetrate through the flooring
material and into the wall studs or wall plate a minimum of
3 / " . Refer to the chart and illustration below.
(19)
4
for
(660)
C O N C R ETE FL OO R APPL IC ATIO N
After properly locating the anti-tip bracket in the opening,
drill pilot holes
or wall plate. Drill
a minimum of 1
washers to secure the bracket to the wall, and use the
wedge anchors to secure the bracket to the floor. Verify the
screws penetrate the wall studs or wall plate a minimum of
3
/ " . Refer to the chart and illustration below.
(19)
4
A N TI - T I P B R A C K E T PL A C E M E N T
36" Model
48" Model
A
WALL PLATE
SUBFLOORING
WOOD FLOOR
Wood floor
3 / " diameter maximum in the wall studs
(5)
16
3 / " diameter maximum in the wall studs
(5)
16
3 / " diameter holes into the concrete
(10)
8
1 / " deep. Use the #12 screws and
(38)
2
A
A
FINISHED
FLOORING
WALL PLATE
SUBFLOORING
CONCRETE
FLOOR
Concrete floor
3 / "
8
A
17 3 / "
(451)
4
3
23 / "
(603)
4
A
FINISHED
FLOORING
1 1 / "
2 (38)
min