Andis MBG-2 Manual Del Usuario página 3

8. Do not use this appliance with a damaged or broken blade or
comb, as injury to the skin may occur.
9. To disconnect turn control to "off" then remove plug from outlet.
10. WARNING: During use, do not place or leave appliance where it
may be (1) damaged by an animal or (2) exposed to the weather.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
To reduce the risk of electric shock, this appliance has a polarized plug (one
blade is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper outlet. Do not change
the plug in any way.
OPERATING INSTRUCTIONS
Please read the following instructions before using your new Andis clipper. Give
it the care that a fine precision built instrument deserves and it will give you
years of service.
Before starting clipper, remove blade guard (some models may not have a blade
guard). Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC
electrical current or as noted on the unit. To start clipper, move switch button to
ON position. To stop clipper, move switch button back to original position. After
using your clipper, rewrap cord and store in a safe place.
USING ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a coarser cut by attaching any of the snap-on
attachment combs made for your clipper. The attachment combs mount easily–
they snap on and off (Figures A & B). These attachment combs guide hair into
the clipper blades and give you precise control of hair lengths. The length of
trim is indicated on the comb: 1/8", 1/4", 3/8" and 1/2".
3