Using The Clock And Timer - GE JGBS10 Manual Del Propietário

Using the Clock and Timer

Throughout this manual, features and appearance may vary from your model.
You have the choice of having the timer show the time
counting down or the time of day. In either case, the
timer will signal at the end of the timer period to alert you
that the time is up.
To Set the Clock
NOTE: When you first plug in the range or after a power
1. Clock pad.
2. + or – pad and the time of day
time by single minutes, give the pads short taps.
3. Clock pad to start the clock.
To Set the Kitchen Timer
1. Kitchen Timer On/Off pad.
2. + and – pads to set the timer. Short taps on
the + or – pad change the timer's setting one minute
3. Once you have set your timer, press the Kitchen
Timer On/Off pad to start timing.
As the timer counts down, a signal will indicate
when one minute is left. After this signal, the display
will count down in seconds. When time runs out, a
Off pad to stop the signal.
To Change or Cancel the Kitchen Timer Setting
When the timer is counting down, use the + and – pad
to change the remaining time, or press the Kitchen
Timer On/Off pad to stop the timer. The timer cannot
Display Clock While Kitchen Timer Is Operating
Clock pad while the timer is operating will
not interfere with the timer's operation; the display will
change to show the clock, but the timer will continue to
49-2000315 Rev. 1
+ pad
Kitchen Timer On/
be cancelled unless you have fully completed "set timer"
instructions above.
the Kitchen Timer On/Off pad again to change the
display back to show the timer.
9