Volume/Tone Push Button - PSC Magellan 8500 Manual Del Usuario

Volume/Tone Push Button

The Volume/Tone Push Button also performs multiple functions depending upon the
duration of time it is pressed:
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
4 Seconds
8 Seconds
a. Diagnostics Mode is meant for use by trained systems support personnel. Users
b. Users should not perform scanner resets except under the direction of trained sys-
4
Table 3. Volume/Tone Push Button Functions
PRESS
FUNCTION
Wakes scanner from
Sleep Mode
Increments volume
Increments tone
Scanner Diagnostics
a
Mode
Resets Scanner
should not need to initiate this function under normal circumstances.
tems support personnel.
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase
speaker volume. When the loudest volume is
reached, a repeated press of the push button
cycles volume back to the lowest setting, then vol-
ume increases on subsequent press(es). Five vol-
ume levels are available.
Press the push button for approximately 2 seconds,
then release. Each time this is done, the beeper will
sound at one of three tones. Stop when the desired
tone (high, medium or low) is sounded.
This mode allows system support personnel to trou-
bleshoot problems with the scanner. Generally
diagnostics are initiated after noting a Field
Replaceable Unit (FRU) Warning (see Table 1).
Cycle power to exit Scanner Diagnostics Mode.
Only system support personnel should perform a
b
reset.
COMMENT
Magellan 8500