Yakima S.U.P. Brah Manual Del Usuario página 2

Install S.U.P. Brah assembly to longest board.
Place Short red Tie-Down Loop
around nose of board.
If your board has fins be sure the loops clear the fins to avoid damaging them.
If your vehicle has an adjustable crossbar system, you must use the maximum
possible crossbar spread when carrying long loads. Do not move your Q-Towers!
Tighten S.U.P. Brah assembly.
Pull strap taught to secure Tie-Down Loops to
board. Secure strap end if necessary.
Center your board(s) on rack.
• Maximum capacity is three boards.
• Boards must be stacked. DO NOT INSTALL BOARDS
SIDE BY SIDE.
• If multiple boards are carried use padding between
boards to protect them.
• Boards can be loaded while in protective surfboard
bags.
• Longest board must be on bottom and shortest board
must be on top.
• Stack boards fins up and toward front of vehicle.
1033596B-2/15
NOTE: Be sure
flat side of buckle
faces downward.
Place Long red Tie-Down Loop
around tail of board.
Do not allow strap to twist.
DO NOT ALLOW BUCKLES TO
SLAM INTO YOUR VEHICLE!
MAXIMUM WEIGHT CANNOT EXCEED
THE LOAD RATING OF THE ROOF RACK.