Installation; Faucet Assembly/Installation - Conglom QL029 Manual Del Usuario

Installation

FAUCET ASSEMBLY/INSTALLATION

- Connect the sprayer head (1) to the sprayer head connector
(2). Push the hose (6) in so that the head aligns properly with
the notches on the faucet neck .
- Remove the gasket (3), metal washer (4), and retaining nut (5)
from the faucet body .
- Install the faucet through the hole in the sink (B) such that the
faucet body completely covers the hole .
- From underneath, secure the faucet to the sink with the
gasket (3), metal washer (4), and retaining nut (5).
- Tighten the retaining nut (5) by hand until it is snug. Use a
wrench to tighten the assembly . Gently tighten the two screws
on the retaining nut (5). Do not over tighten.
- Hand-tighten the hose (6) to the faucet outlet (7). Tighten the
fittings using two wrenches. Hold the faucet outlet (7) steady
with a wrench while turning the hose fitting with another
wrench until it is snug . Failing to use two wrenches can
damage the faucet . Do not over-tighten .
- Install the counterweight (8) a couple of inches from the
bottom of the hose (6) on the side closest to the faucet head.
There should be no slack in the hose .
- Connect the water supply lines (not supplied) to the water
connectors (9) .
QL029
Faucet body
Gasket (3)
Retaining nut (5)
Water connectors (9)
Counterweight (8)
Faucet outlet (7)
Hose (6)
6 6
Sprayer head
connector (2)
Sprayer head (1)
Sink
Metal washer (4)
Screws
Faucet outlet (7)
Hose (6)
Water connectors (9)
1/2" NPS thread
1/2" FIP water supply
line compatible
(not supplied)