Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Plug in Refrigerator
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similar qualified person. Do
not use a cord that shows cracks or abrasion damage along its
length or at either the plug or connection end.
1. Set control switch at top of cabinet to the OFF position.
2. Plug into a grounded 3 prong outlet.
Install Side Trims
The side trims cover the space between the refrigerator and the
adjacent cabinets. There is a trim piece taped to each side of the
refrigerator. Install each trim piece to the side of the refrigerator to
which it is taped.
1. Remove the tape attaching the trim pieces to the sides of the
refrigerator. Set the trim pieces aside.
2. Remove the four screws from the side of the refrigerator
cabinet.
A
A. Side trim screws
3. Using the original holes and the screws removed in Step 2,
fasten the side trim to the refrigerator cabinet.
NOTE: Make sure to fasten each trim piece to the side of the
refrigerator cabinet from which it was removed. The tapered
shaped edge should be forward with the notches aligning with
the door hinges.
Top View
C
A. Side trim
B. Adjacent cabinet
Move Refrigerator to Final Location
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
A flush installation is NOT possible with a 24" (60.9 cm) deep
■
opening.
To avoid floor damage, make sure levelers are raised (not
■
touching floor) and refrigerator is on rollers before moving.
Use the installation block, attached to the door hinge, as a
■
reference to make sure the refrigerator is pushed back far
enough into the opening, so that when the panels are installed
they will be flush with the adjacent cabinets.
After the refrigerator is leveled and aligned, remove the
■
installation block from the door hinge and use it to check the
spacing between the panels and adjacent cabinets.
NOTE: The installation block is designed to provide accurate
spacing for 3/4" (1.9 cm), 3/8" (9.53 mm) and 1/8" (3.18 mm).
3/4"
(1.9 cm)
1. Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
2. Move the refrigerator straight back and evenly into the
opening. Be sure that the water tubing is not kinked and the
power supply cord is on top of the refrigerator.
NOTE: If the power supply cord is behind the refrigerator, it will
not install properly.
A
B
C. Door
1/8"
(3.18 mm)
3/8"
(9.53 mm)
19
Tabla de contenido
