Kasco 8400EJF Manual Del Propietário página 5

Note: Extra hardware may be included.
TOOLS & SUPPLIES NEEDED
A. Anchors or stakes for installing unit (3)
B. 240V Electrical Supply near pond on a post
C. Three 30cm pieces of 2.54cm galvanized pipe for
weighting ropes (optional)
D. 7/16" (11mm) Socket & Wrench (1)
E. 7/16" (11mm) Wrench (1)
F. 9/16" (14mm) Socket & Wrench (1)
F. 9/16" (14mm) Wrench or adjustable crescent
wrench (1)
G. Flat head screw driver (1)
8400EJF, 3.1EJF, & 3.1EVFX Assembly
STEP ONE
Remove all contents from package and place on a
clean, fl at surface. Inspect the shipment for any dam-
ages. Make sure you have all the parts needed.
STEP TWO
Arrange the three Float Sections (Part B1) upright
(plug on bottom) so the overlap of one section aligns
with the next section and loosely push the three sec-
tions together to form a continuous ring.
Float up
STEP THREE
Position one Top Float Bracket (Part B2) so that the
bolt holes in the bracket align with the bolt holes in
the two adjoined fl oat sections and insert two 9" Black
Coated Bolts (Part B4) through the assembly. This
may require some minor repositioning of the fl oat sec-
tions as you push the bolt all the way through. Do not
force the bolt through. Repeat for the remaining two
joints.
STEP FOUR
Turn the assembly upside down and place the Bottom
Float Brackets (Part B3) over the bolts, the ends of
which should now be extending through the assem-
bly. Loosely install the six Lock Nuts (Part B5) on
the ends of the bolts (do not tighten yet). Connect the
top and bottom brackets using three 1/4" x 3/4" Bolts
(Part B7) with the three 1/4" Lock Washers (Part B8)
and 1/4" Nuts (Part B12) and tighten using the 7/16"
(11mm) wrench and socket.
STEP FIVE
Stand the assembly on its side and center the Top
Screen (Part B10) inside the three Top Float Brack-
ets. Attach the screen by spanning each Top Screen
Clip (Part B11) across the two innermost rings on the
screen and the hole in the fl oat bracket. Insert the
Brass Screws (Part B14) and attach with 1/4" Lock
Washers and 1/4" Nuts to secure the screen to the fl oat
assembly.
Float down
(plug)
STEP SIX (For 8400EJ & 3.1EJ)
Return the assembly to the upside down position and
place the motor assembly (Stainless Steel can side
up, black pump down) in the center of the fl oat. At-
tach the motor to the fl oat using the Unit Mounting
Brackets (Part B6). The notch in the center of the Unit
Mounting Brackets should be positioned over the top
ring of the cage and should be attached to the fl oat
bracket using the two middle holes of the fl oat bracket
on 8400EJ & 3.1EJ.
Tighten using the 1/4" x 3/4" Bolts with 1/4" Lock
Washers using the 7/16" socket and wrench. (See pic-
tures) Note: If you have trouble positioning the Unit
5