Technical Parameters - Elko EP iNels IDRT3-1 Guia De Inicio Rapido

Technical parameters

Inputs
Temperature measuring:
Range / accuracy of
temp. measuring:
Heating / cooling circuit
correction:
Manual ontrol of heating /
cooling circuit:
External temperature sensor:
Type external sensor:
Temperature measurement
range:
Temperature measurement
accuracy:
Communication
Installation:
Display:
Backlight:
Power supply
Supply voltage / tolerance:
Dissipated power:
Rated current:
Connection
Terminals:
Operating conditions
Operating temperature:
Protection degree:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Dimensions and weight
Dimensions
- plastic:
- metal, glass, wood, granite:
Weight:
TECHNICAL SUPPORT | E-mail: [email protected] | Mobil: +420 778 427 366 | Tel.: +420 573 514 276, +420 573 514 211 | Fax: +420 573 514 227 | www.inels.com
Made in Czech Republic
IDRT3-1
YES, built-in thermo sensor
0 .. +55 °C;
0.3 °C from range
±3, ±4 or ±5°C
2x buttons
YES, the connection between
AIN1/DIN1 and AIN2/DIN2
TC/TZ
-20 °C .. +120 °C
0.5°C from range
BUS
symbol display
YES
27 V DC, -20 / +10 %
max. 0.5 W
20 mA (at 27V DC), from BUS
0.5 - 1 mm 2
0 .. +50 °C
IP20
II.
2
vertical, downward with BUS terminal
into installation box
85.6 x 85.6 x 50 mm
94 x 94 x 50 mm
76 g (without frame)
ELKO EP, s.r.o. | Palackého 493 | 769 01 Holešov, Všetuly | Czech republic | e-mail: [email protected]
Warning
Before the device is installed and operated, read this instruction manual carefully and with full
understanding and Installation Guide System iNELS3. The instruction manual is designated for
mounting the device and for the user of such device. It has to be attached to electro-installation
documentation. The instruction manual can be also found on a web site www.inels.com. Attention,
danger of injury by electrical current! Mounting and connection can be done only by a professional
with an adequate electrical qualifi cation, and all has to be done while observing valid regulations.
Do not touch parts of the device that are energized. Danger of life-threat! While mounting,
servicing, executing any changes, and repairing it is essential to observe safety regulations, norms,
directives and special regulations for working with electrical equipment. Before you start working
with the device, it is essential to have all wires, connected parts, and terminals de-energized. This
instruction manual contains only general directions which need to be applied in a particular
installation. In the course of inspections and maintenance, always check (while de-energized) if
terminals are tightened.
2/2