Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Bundle the AC power cord and
the display interface cable.
1 Do not forcefully pull on the cables. Leave
some slack at the connected end as you
thread the cables through the center hole on
the stand. (Stand has two holes to thread the
cables on the left and right sides.)
2 Thread the cables through either the left or
right side hole of the stand.
Slacken the cables.
2
Cardboard or cloth
Note
Do not forcefully pull the cable through the hole as
the metallic part of the connector may scratch the
floor. To avoid any damages to your floor, cover the
floor with a piece of thin cardboard or a cloth during
the installation.
1
Thread the black and white
display cables together
through the hole.
3
Attach the cable cover.
1 Push any excess of cable inside the cable
compartment, and slide the cable cover down
until the four tabs of the cable cover snap into
place.
Cable cover
2 Affix the cable cover with the two screws for
the cable cover.
Cable cover securing screw
M4×L12
7
(US)
US
Tabla de contenido
