Troubleshooting; Need Help - Lorex LIVE SD 4.3 Serie Guía Para Usuarios

Troubleshooting

Problem
No video displayed
on the monitor
Monitor screen keeps
turning off
The camera is not
detected; "Out of
Range" is shown on
the monitor
Feedback / squealing
noise coming from the
monitor
Touch buttons on the
monitor aren't working
Cannot access Main
Menu
Monitor is beeping
Display is frozen

Need Help?

Product Support is available 24/7 including product
information, user guides, quick start guides, and FAQ's
at www.lorextechnology.com/support
Solution
• Press and hold the
for 3 seconds to power on the
monitor.
• Monitor is out of batteries. Plug in
the monitor power adapter.
• Scan Mode is on. Press any button
to turn the screen back on. Press
to exit Scan Mode.
• If none of the solutions above work,
press the Reset button on the back
of the monitor.
• The monitor battery is low. Plug in
the monitor power adapter.
• Scan Mode is on. Press any button
to turn the screen back on. Press
to exit Scan Mode.
• Make sure the camera is powered
on.
• The camera and monitor may be
out of range. Extend the antennas
on the monitor or move the monitor
and camera closer together.
• You may need to pair the camera
and the monitor again. See
"Pairing Additional Cameras" on
page 38 for details.
• Wrong channel selected. Press
repeatedly to select a channel
with a camera connected to it.
• Your camera and monitor may be
too close to each other. Move them
further apart.
• Lower the monitor volume.
• Press the Lock button (
side of the monitor to unlock the
touch buttons.
• You cannot access the Main Menu
during recording. Press A or M to
stop recording, then press
access the Main Menu.
• If Alarm Volume is turned up, the
monitor will beep when motion
is detected. See "Configuring
Beeping Volume" on page 18 to
disable the Alarm Volume.
• Press the Reset button on the back
of the monitor using a paper clip or
other thin object to reboot. Settings
and saved files are unaffected.
43
button
) on the
to