Belkin TuneCast 3 Manual Del Usuario página 11

Troubleshooting
Issue
The audio is distorted.
Solution 1 Decrease the volume of your audio device until you no longer hear distortion. Keeping the device's
volume level at or below three-fourths of the maximum should prevent audio distortion. However, don't turn it
so low that the audio-detection circuit shuts down your TuneCast 3.
Solution 2 Tune your car stereo and the TuneCast 3 to a different frequency.
Issue
TuneCast 3 automatically turns off when I am playing music.
Solution Turn up your music-player volume. If the audio-detection circuit does not detect audio for 10 minutes, it
shuts down the unit to preserve the battery. Possible causes of this s
ituation are having the music-player volume too low or pausing the player for longer
than 10 minutes.
Issue
The battery indicator does not seem to display the correct battery status.
Solution Be sure to use non-rechargeable alkaline batteries. Other battery types can cause TuneCast 3 to display
incorrect battery life.
EN
Issue
My TuneCast 3 automatically powers off when I turn off my vehicle or unplug the unit from my car's
power outlet.
Solution TuneCast 3 automatically turns off when external DC power is removed.
Issue
I am unable to get clear FM reception.
Solution 1 Tune your car stereo and the TuneCast 3 to a different frequency.
Solution 2 In some instances, lowering the car antenna (in cars where available) improves the clarity of the TuneCast
3 signal.
Solution 3 Change the stereo/mono setting to mono mode. This may improve signal reception, but the audio
will be monaural instead of stereo.
Solution 4 If used indoors, attach or reposition the antennae on the stereo receiver.
Issue
TuneCast 3 does not appear to be saving my settings.
Solution Be sure NOT to release the button until the audible beep occurs or the status bar indicator is
complete. Your settings are stored in memory when the TuneCast 3 display returns to normal operation.
Troubleshooting | 08