How To Install; How To Assemble; Installation Check; How To Disassemble - Richell 94111 Manual De Instrucciones

How to install

The positions of fixing bolts depend on desired
gate width.
Note: Tighten the fixing bolts securely with
a hexagon wrench.
Settled width and the position of fixing bolts
lFor an opening width of
lFor an opening width of
lFor an opening width of

How to Assemble

1. Determine the direction for opening door and set the product against the wall.
2. Tighten the upper adjuster knob until the rubber of adjuster touches the wall surface.
3. Tighten the upper adjuster knob until the clearance between the product and wall is the same on both sides.
4. Tighten the lower adjuster knob to make the product vertical, and stretch the product fully.
Adjuster Knob
※ Fine-tune the width of installation
Place Knob in the correct
direction as shown below
View of Knob facing
correct direction
Adjuster Bolt

Installation Check

If correctly installed, the product should not feel loose or wobbly when tugged.
This product should be attached to wall securely and safely to ensure pet safety
and prevent damage to product/wall.
Please adjust into a safty size
that dogs can not escape or
getting pinched.

How to Disassemble

Rotate Adjuster Knobs counterclockwise to loosen and remove.
Cautions!
l Be careful not to drop the product during disassembly.
lPlease note that product specifications and design may change without prior
notice for the purpose of quality improvement.
lThere may be coating cracks at some joints and each product may experience
different coloration of the wood grain as frames are made of natural wood.
lIf you find something wrong with this product, please let us know. Thank you!
28.3 - 29.1"
lFor an opening width of
32.3 - 33.9"
lFor an opening width of
37 - 38.6"
lFor an opening width of
using adjusters on both sides.
※ Attach the rubber skid to the bottom
to prevent scratches to floor surface.
Adjuster Panel
Washer
Spring Washer
Fixing Bolt
Hexagon Wrench
Panel with Door
29.1 - 30.7"
33.9 - 35.4"
38.6 - 40.2"
Cautions!
lInstall the product against the wall vertically.
lThe bottom of product should contact the floor.
Warnings!
lTighten adjusters equally on both sides to prevent
overturning or damage to the product.
How to open or close the door
Turn the lock up and slide it as shown.
Lock
2
As shown the adjusted bolts can not be
installed in the holes of fixed bolts.
lFor an opening width of
lFor an opening width of
lFor an opening width of
90 - degrees
90 - degrees
Less than 2.4"
Designed by:
Richell Corporation, Japan
Distributed by:
Richell USA, Inc.
Grand Prairie, Texas 75050
Phone (972) 641-9795 Fax (972) 641-8495
Visit us at www.richellusa.com
MADE IN VIETNAM
30.7 - 32.3"
35.4 - 37"
40.2 - 41.3"
2.4" and above