Technical Specifications; Technical Data - Marmitek SM10 X-10 Modo De Empleo

If I press the 'All Off' button, all my modules are switched off, but then they are
switched on again.
The appliance connected to the SM10 keeps the contact closed or constantly gives off power.
My device modules do not respond to the SM10.
• You are using a setting that sends the command 'All Lights On'. Only lamp modules can
respond to this command. Choose another setting for your SM10 (see the SM10 product
sheet for more information).
• Is the SM10 connected to the same phase as the other modules?
Can the PH7208 Extra X-10 indoor siren also be controlled using the SM10?
Yes, it can. Set the mode switch to position 2 and make sure that both units have been set to
the same HouseCode.
Do you still have questions? Please check out www.marmitek.com for more
information.

TECHNICAL SPECIFICATIONS

Supply:
Current consumption:
Signal transmission:
X-10 transmission:
Sends X-10 Key codes:
For use in a 3 phase installation: FD10 (3x) or CAT3000 required.
Input impedance:
Connectors:
Surrounding temperature:
Dimensions:
Specifications may be modified without prior notice.
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its
packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should
be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and
other electric and electronic equipment via designated collection facilities appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For
more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal
service, or the shop where you purchased the product.
8
230VAC 50 Hz, 2 Watt
< 20 mA capacity
> 2,5Vpp, 120 kHz ± 2kHz
1 pulse burst at 0˚ ,60˚ and 120˚
All units Off, All Lights On, On, Off.
> 180 Ohm (P-N) for 120 kHz
Screw connectors for switch contact.
-10°C to +50°C (business premises)
-20°C to +70°C (warehouse)
56x91x38mm
© MARMITEK