Oerlikon CITOCUT 10KT Instrucciones De Seguridad, Empleo Y Mantenimiento página 5

Burned nozzle.
1. Current too high.
2. Nozzle damaged or loose.
3. Nozzle touching the workpiece
4. Excessive slag: low gas plasma pressure.
6.0 TROUBLESHOOTING
After starting, the power source may show operational errors on
the display (Ref. 3 - Picture 1 Page 2.), as shown in the table be-
low (TABLE 2.). These errors can be remedied or are irreversible.
TROUBLESHOOTING)
TABLE 2. (
DISPLAY
F14
F10 - F11 - F12 - -F13
F 15
F20 - F30 - F51 - F52 - F53 -
F54 -F55 - F56
TROUBLESHOOTING
RESETTING
Make sure that the cap is properly inserted. Switch the power source off and then on again.
Switch the power source off and then on again. If the "fail" persists call the assistance centre and communicate the type
of error.
Make sure that the torch button is not pressed when switching the power source on. Switch the power source off and
then on again.
Switch the power source off and then on again. If the "fail" persists call the assistance centre and report the type of error.
7.0 MAINTENANCE
CAUTION: DISCONNECT THE EQUIPMENT FROM THE ELEC-
TRICITY MAINS BEFORE DOING ANY MAINTENANCE
WORK.
7.1 MAINTENANCE OF THE EQUIPMENT
Twice a year, depending on the degree of use of the unit, inspect:
- The cleanliness of the equipment
- The electrical and gas connections
- The air filter-regulator.
For all operations:
- Remove the equipment cover.
4 EN
EN