General Information - Siemens VDO MTCO 1324 Instrucciones De Servicio

General information

The symbols in these operating instructions
have the following meanings:
ATTENTION!
The text next to this symbol contains
important information, which has to
be observed to prevent the device
from being damaged.
NOTES
or additional information, which, if
not observed, may lead to failures, are
marked by this symbol.
Please observe the notes listed
below!
❒ Notes for the operation of the
Kienzle MTCO 1324
• Only open the drawer for inserting or
removing the charts. Otherwise, keep it
shut at all times to avoid damages and to
prevent it from being contaminated.
• Do not use the drawer as a kind of sup-
port, like for example, for writing on the
charts.
• Do not use any abrasive detergents for
cleaning the device, nor any solvents like
diluent or naphtha.
© Siemens VDO Automotive AG
• The Kienzle MTCO 1324 will be installed
and sealed by authorised persons.
Please do not intervene at the device
or at the supply lines.
❒ Notes for the handling of the charts
• The chart is driver-specific and may
thus not be transferred to other
persons !
• Use charts provided by the manufacturer
(original Kienzle tachograph charts). Make
sure that the full-scale value and the
approval mark correspond to those on the
tachograph, ➥ see page 36.
• Only insert perfect charts, they may
neither be folded, nor be torn at the
perimeter and / or at the opening, nor be
wavy or damaged in any other way!
• The recorded charts must be safely stored
and protected against damage, see also
Section 15 of the CR (EEC) No. 3821/85.
❒ Reference to legal provisions
• Those who modify the settings of the con-
trolling device or at the signal feed line,
which influence the record issued by the
controlling device, especially when intend-
ing to deceive, may violate official penal
provisions or administrative regulations!
25