Nero Backitup 2 Software - Verbatim Pro 2-Disk RAID Guia Del Usuario

To change RAID mode, follow these steps:
WARNING: Changing RAID mode will delete all data on the drive. Do not change the
setting of the RAID Mode Switch unless you have first saved all of the data from the
drive, including the bundled Nero software, to another storage location.
1) If you have any important data stored on the drive, first save the data to another
storage location. Then safely remove the drive and turn off the power to the drive.
2) While power is OFF, use a pen or other instrument to slide the RAID Mode Switch to the
desired position.
3) Power up the drive. The LEDs will flash BLUE while the internal firmware is
reconfiguring the RAID mode. When flashing turns to solid BLUE the drive has
successfully reconfigured, though remains uninitialized, unpartitioned and unformatted.
4) Attach the drive to your host computer using either USB or eSATA. Your computer
may show it as an unknown device, which confirms that the drive remains uninitialized,
unpartitioned, and unformatted.
5) Format the drive. For NTFS or HFS+ use the computer's operating system to reformat.
If you prefer to use FAT32, then you can use the FAT32 formatting utility that
was supplied to you as a file saved on your hard drive (Verbatim_FAT32_tool.exe).
You can find more information on formatting from the support web site listed under
Getting Help.

Nero BACKITUP 2 Software

Nero BACKITUP 2 back up software is included on the hard drive. Double click the Nero
folder on the drive and then double click the setupx file to start installation. The Nero
Installation window will appear. Follow the set up wizard to install the software.
6