Assembly; To Assemble The Hand Guard And Loop Handle (Lrt-Ex200) - RedMax LRT-EX200 Manual De Usuario

2. Remove the spark plug cap from the spark plug.
3. Put on protective gloves.
4. Make sure that the blades are not damaged or bent.
Always replace a damaged or bent blade.
5. Make sure that the screws to the blades are tight.
To do a check of the bevel gear and gearbox
WARNING:
the product become cool before you touch
the bevel gear and gearbox.
• Do a visual check for damage and deformation.
Safety instructions for maintenance
Read the warning instructions that follow before you use
the product.
• Always stop the product fully and remove the spark
plug cap from the spark plug before you do
To assemble the hand guard and loop
handle (LRT-EX200)
1. Loosen the 2 screws and remove the coupling.
2. Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts.
3. Slide the loop handle and hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
8
To prevent burn injuries, let

Assembly

maintenance on the product. Make sure that the
cutting equipment has stopped fully.
• The transport guard must always be attached to the
cutting attachment when the product is not in
operation.
• Always wear heavy-duty gloves when you do
maintenance on the cutting attachment. The cutting
attachment is very sharp and can cause injury.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Use only original spare parts for repairs.
5. Fit the nut and screw. Do not overtighten.
6. Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION:
hand guard must not be fitted behind the
arrow marked on the shaft.
7. Fit the clutch sleeve and tighten the two mounting
bolts.
The loop handle and
1472 - 002 - 11.11.2020