To Adjust The Angle Of The Cutting Unit; To Adjust The Friction For Angle Adjustment - RedMax LRT-EX200 Manual De Usuario

5. Make sure that the end of the cutting equipment
does not touch the ground.
6. Be careful and work slowly until all the branches are
correctly cut.

To adjust the angle of the cutting unit

The cutting unit can be adjusted in 10 different positions.
WARNING:
unit when you adjust the angle.
1. Let the engine run at idle speed and make sure the
cutting unit does not move.
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position. Use 1 of
the procedures that follow.
a) Use the handle.
10
Do not operate the cutting
b) Push the end of the cutting unit against a stable
surface.
4. Release the position adjustment handle to lock the
cutting unit.
5. Push the cutting unit against the hedge to make sure
that it is locked.
To adjust the friction for angle
adjustment
WARNING:
unit when you adjust the friction.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit
3. Pull down the position adjustment handle.
4. Tilt the cutting unit to the applicable position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to try the
friction.
Do not operate the cutting
1472 - 002 - 11.11.2020