To Disassemble The Product For Transport; To Set The Product In Transport Position; Maintenance; To Perform Maintenance On The Attachment - RedMax LRT-EX200 Manual De Usuario

To disassemble the product for
transport
WARNING:
when the product is in transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting attachment.
3. Turn the knob (A) to loosen the coupling.
A
4. Push and hold the button (B).
B
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
To do daily maintenance
A
1472 - 002 - 11.11.2020
Do not start the product
C

Maintenance

B
5. Pull the cutting attachment (C) straight out of the
coupling.
6. Make sure that the cutting attachment and the
product can not move during transportation.

To set the product in transport position

WARNING:
when the product is in transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit.
3. Pull down the position adjustment handle.
4. Fold the cutting unit to make it parallel to the shaft.
1. Examine that the blades (A) do not move when the
throttle/power trigger is released or when the choke
is in the start position.
2. Examine that the hand guard (B) (applicable for
LRT-EX200 with gasoline powered units) is not
damaged. Replace the guard if necessary.
To do general maintenance
To lubricate the bevel gear and
gearbox
WARNING:
the product become cool before you touch
the bevel gear and gearbox.
Note:
New products are first filled with grease after
approximately 20 hours of operation.
Do not start the product
To prevent burn injuries, let
11