Setting Up The Refrigerator - Samsung RF18 Serie Manual De Usuario

Setting up your french door refrigerator
FLOORING
For proper installation, this refrigerator must be placed on a level
surface of hard material that is the same height as the rest of the
flooring. This surface should be strong enough to support a fully
loaded refrigerator, or approximately 223lbs(106kg). To protect
the finish of the flooring, cut a large section of the cardboard
carton and place under the refrigerator where you are working.
When moving the refrigerator, be sure to pull it straight out and
return it to position by pushing it straight in.

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between it and the wall. Refer
to installation instructions in this manual. (page 13, selecting the best location for the Refrigerator)
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
NOTE
Check the accessories listed below.
Compression fitting
Required Tools (Not provided)
Phillips screwdriver(+)
14_ Setting up your french door refrigerator
NW2-FDR_DA68-01845C-26_EN.indd 14
Compression nut Fastener
Flat-blade screwdriver(-) Socket Wrench
(10mm) (for bolts)
Hex Wrench (3/16") Pliers
(for Mid hinge)
2019-01-22 4:41:47